; Drawing 3 Rear tool T50
; programme details
;
;
;
 G21 *                         ; Metric programme
 G90 *                         ; In absolute
 G40 *                         ; Make sure radius offsets are off
 T0000 *                       ; use T0 offset as tool change position
 G0 Z0.0 X0.0 *                ; Tool change position
 T5050 *                       ; Set current tool offset
 M06 *                         ; Prompt for tool change
 F25. *                        ; Set feed rate for current tool
 S1250. *                      ; Set spindle speed
 M03 *                         ; Turn spindle on
 G00 G41 X0.0 Z0.0 *
 G01 X-5.0 *
 G02 X-15.0 Z-10.0 I0.0 K-10.0 *
 G41 G01 X-15.0 Z-35.0 *
 G03 X-20.0 Z-40.0 I-5.0 K0.0 *
 G41 G01 X-25.0 *
 G00 G40 X-30.0 Z5.0 *
 T0000 *              ; Use T0 offsets as tool change position
 G00 Z0.0 X0.0 *      ; Park position at end of programme
 M05 *                ; Turn spindle off
 S0. *                ; Set S to 0
 M30 *                ; End of programme, rewind, prompt to run again